Simplicity Garden Tractor
We offer free “technical support” about most outdoor power equipment. Jim doesn’t know all the answers but helps when he can. Disclaimer: He isn’t always right! We have quite a few of the questions asked on our web site and according to the calls and e-mails we get, you like reading them! Here’s more:
Q: I have a Yard Machine (Gold Series) 17.5 hp engine. Because of work I do not get to cut the grass until late evening, so I install a couple spot lights to allow cutting at night.
Unfortunately the lights are draining the battery. What are my options? I am thinking of installing an alternator. is it very difficult?
A: You should be able to order out a bigger amperage output alternator and rectifier and come up with enough power to stay ahead of your added lights.
Q: I have an early 1970′s Jacobsen Super Chief, Hydro 1200 tractor, with a Rand
Hydro-Transmissions unit in it, number 90-4029. I would like to know which transmission oil to use. I have been told by one dealer to use Dextron automatic transmission oil and be another dealer to use regular hydraulic fluid. I would certainly appreciate knowing for sure which type of oil to use.
A: I would use the red Dextron III transmission oil.
Q: Is there a way for me to test the alternator on my Toro Wheel Horse 520-H garden tractor? To be honest, I can’t even locate an alternator. According to owners manual the alternator is 12 Volt, 20 amp. Regulated. When the battery is fully charged the voltmeter reads 12 volts. As it discharges there is no voltage reading. The 30-amp fuse tests good. If you can help me locate the alternator I can check electrical connections. Apparently this is some kind of pulse alternator since I can’t locate it. The engine is an Onan P-220-G I/10955D.
A: I think if you would install a new rectifier you would be working fine again. First make sure you have power to the center wire on the regulator with the ignition key on.
Q: I have a Scotts 2554 and the electric clutch makes a squealing sound when the mower is not engaged. When the mower is engaged the sound goes away. I understand that the clutch has a brake adjustment. How do I adjust it? The mower has a Kohler 25 hp motor with serial number 3034903061. If the bearing in the clutch is bad how much trouble is it to take it off and where is the best place to get a replacement part?
A: You adjust those self locking nuts until you have about .010 clearance in the brake. It sounds to me like you have a bad bearing and on that clutch I do not think the bearing can be replaced. That would make you have to replace the complete clutch.
Q: Help… mowing season is here and after servicing my Simplicity mower I now find that the mower starts and runs fine. However…when I engage the PTO the engine stalls. I replaced the PTO dash switch and unfortunately this did not help. Do you have any suggestions or thoughts that might assist me with my troubleshooting?
A: Yes, check out the wiring or the seat switch for an open circuit. Check out the hydrostatic switch and the switch on the brakes.
http://www.jimsrepairjimstractors.com 1-800-618-8738
Let’s Connect!